The Radial Bassbone OD is a bass preamp with two instrument input channels, each of which is fully equipped with a level control, super powerful passive-interactive EQ and a low frequency filter to help eliminate resonance.

Channel 1 is further equipped with Drag Control load correction to optimized the tone and feel when using a vintage passive instrument such as a vintage Fender bass. Channel 2 takes a different slant with a PZB booster that increases the sensitivity and load to 10 meg ohms to optimize it for use with piezo transducers as commonly used on upright bass. Toggling between channels is done using a footswitch and both channels may be mixed together by depressing the blend switch, should a dual pickup system be in use. Outputs include a 1/4' instrument level output to feed the on-stage amplifier plus a low-Z balanced Radial DI box output to feed the PA system. The XLR output can be assigned pre or post effects to suit the engineer's preference. A separately buffered tuner output works with the mute footswitch for quiet on-stage tuning.

For bassists that employ effects, both input channels can share the same pedals by connecting via the built-in send & receive effects loop. This is augmented with an on-board bass overdrive with control over the drive level, tone and a wet-dry mix that lets you add slight grit or over the top distortion to the signal path. The OD footswitch may be assigned to the loop, overdrive or both. Finally, a built-in headphone amp with 3.5mm… read more output lets you use the Bassbone on the bus for those long drives between gigs.

WARNING: Cancer and Reproductive Harm - www.p65Warnings.ca.gov.

read less