Moog Werkstatt-01 Analog Synthesizer Kit

OSCILLATOR SECTION
- Single VCO w/ frequency control (8Hz to 16KHz)
- Saw and square waveshapes w/ control for square pulse width
- Envelope or LFO selectable Mod Source that can be assigned to PWM or Pitch w/ Amount control
- Ability to PWM the square wave

FILTER SECTION
- Classic 4-Pole Moog Ladder Filter w/ Resonance control (20Hz-20KHz)
- Select between the Envelope generator and LFO as Mod Source.
- Polarity switch (+/-) and amount knob for control of filter cutoff modulation

LFO SECTION
- Selectable Square or Triangle waveshape w/ rate control (2Hz-600Hz)

VCA/AMP SECTION
- Select between the Envelope Generator or ON (Drone)

ENVELOPES SECTION
- Controls for Attack & Decay time w/ Sustain On/Off switch

KB SECTION
- One octave low-note priority legato keyboard w/ glide control

PATCHBAY:
- VCA Input: 0V to +5V in VCA EG Mode, +/-2.5V in VCA ON Mode
- VCF Input: -5V to +5
- VCO LINEAR FM Input: +/-2.5V - NOTE: this is an inverting control input
- VCO EXPONENTIAL FM Input: -5V to +5V, 1V/Octave trimmable
- LFO CV Input: 5V to +5V - NOTE: Negative CV slows LFO more than the panel
- VCF AUDIO Input: Unbuffered/Unmixed AC coupled input to VCF
- 2x KB CV Output: 3V/semitone from 1 keyboard - NOTE: Attenuate for 1V/Octave
- 2x TRIG Output 5 msec pulse, 0 to +5 V signal generated from low-note priority
- 2x GATE Output: 0 to +5V signal generated from low-note priority
- 2x EG Output: 0 to +5V signal, Simple ASD or AD type Envelope Generator
- 2x LFO Output: -2.5 to +2.5V Triangle or Square wave, selected via LFO Switch
- 2x VCF Output: -2V to +2 V signal for audio or CV uses
- 2x VCO Output: 0V to +5V VCO signal, wave selected by VCO Wave Switch

Rear Panel:
- AUDIO Output Nominal +/-1.5V Signal
- POWER+12VDC Center Positive w/ 1.2A Wall transformer
- POWER CONSUMPTION 1.8 Watt AVG