Red Panda Bit Buffer Device
No longer available at zZounds




Ensure lively tone on even the longest cable runs with the Bit Buffer. Its low-noise Burr-Brown op amp keeps your sound clean without high-frequency loss.
Overview
The Bit Buffer is a tiny (2" x 1.5") buffer that uses an ultra-low distortion, low-noise Burr-Brown op amp. Place it at the beginning of your pedal chain to prevent high-frequency loss (tone suck), or right before a long cable to a pedalboard or amp.
The Bit Buffer is always on when power is connected. An internal LED is visible below the power jack.
The Bit Buffer is always on when power is connected. An internal LED is visible below the power jack.
Specs
- Size: 2" x 1.5" x 1.2"
- Input Impedance: 1 M Ohm
- Output Impedance: < 1 k Ohm
- Frequency Response ( 3 dB): 20 Hz - 40 kHz
- Signal-to-Noise Ratio: 90 dB
- Power: 9-18 VDC, center negative
- Current: 20 mA
- Input Impedance: 1 M Ohm
- Output Impedance: < 1 k Ohm
- Frequency Response ( 3 dB): 20 Hz - 40 kHz
- Signal-to-Noise Ratio: 90 dB
- Power: 9-18 VDC, center negative
- Current: 20 mA
No longer available at zZounds
In most cases, a product is unavailable because it has been discontinued by the manufacturer
This is a carousel with product cards. Use the previous and next buttons to navigate.