Moog Minifooger MF Flange Flanger Pedal

No longer available at zZounds
Get the full range of flange with this Minifooger's responsive controls. Flip the type switch to go from a vocal-sounding flanger to a more traditional tone.

The Moog MF Flange is a 100% analog BBD based phase manipulator with a dedicated voicing switch and mono or stereo output capabilities. The two-position Type switch toggles between two voice modes: vocal or a traditional flanger. There is also a fully sweep-able feedback knob, which determines the resonant peak of a sweep, as well as a wide-range Time control that pushes the creation of sound capabilities of this analog effect far beyond the limitations of a traditional flanger.


Rate: At Minimum position sweeps are gradual and fluid. As rate is increased, the movement becomes tighter and more focused. At maximum position, the modulation sound becomes is rapid and transitions to hard, percussive pulsing.
Depth: Determines the amount of modulation applied to the delay time. As depth is increased, the sound transitions from light motion and phasing all the way into massive multi-octave sweeps.

Time: At maximum position you can easily craft traditional or vocal, metallic flange sounds. As the Time control position is reduced, delay time is increased and sounds become thicker and warmer. At Minimum position, the MF Flange is capable of approaching analog chorus.

Feedback: This control brings focus and resonance to the sweep of a sound. We recommend starting at mid position and then adjusting from there. WARNING: at maximum position this control can cause the MF Flange to self-oscillate.

TYPE: The lower position subtracts feedback from the mix and dry signal, read more producing a more vocal sound - shifting the comb filter 1/2 octave. In the Upper position, feedback is positively summed with the input signal and dry signal producing a more traditional flanger sound.

EXPRESSION PEDAL INPUT: This input is assigned to the Time control. Use an expression pedal to manually sweep through the delay frequency range of the MF Flange.

MONO/STEREO SWITCH:To access both outputs (in bypass), you will need to remove the bottom of the MF Chorus and set this switch to Stereo. Then use a 1/4" TRS to TS insert cable or TRS to TS splitter.

WARNING: When set to Stereo and in bypass, excessive loading may occur. To avoid this, set this switch to Mono. A stereo output will still be present.


- True Bypass
- 100% analog wide-range Flange
- Extreme time and phase manipulation possibilities
- Mono or Stereo out
- Designed to perform with any Guitar, Amp, or Bass guitar configuration
read less

- Signal Path: 100% Analog
- Bypass Type: True bypass
- Power: +9VDC
- Weight: 18oz (0.5kg)
- Enclosure: Cast aluminum
- Dimensions: (D x W x H) 5.75 x 3.25 x 2.25" (14.4 x 8.3 x 5.8cm)
- Delay Time: <0.540mS - 16mS (0.340-20mS with modulation)
- LFO Rate: <.025Hz - >11Hz
- LFO Shape: Exponentiated Triangle
- Expression: Controls Time (Max Input level +5VDC)
- Input Impedance: >1 MegaOhm
- Output Impedance: 1000 Ohm Max
- Max Input Level: +7.5dB
- Current: 18mA Nominal / 22mA Max
- Output Stereo: Left (Mono) = Dry + Wet / Right = Dry - Wet

For support or warranty questions, please contact the manufacturer:
Phone: 828-251-0090

No longer available at zZounds

In most cases, a product is unavailable because it has been discontinued by the manufacturer