dbx Di1 Active Single Channel Direct Box

No longer available at zZounds
This is a carousel with one large image and a track of thumbnails on the left side. Select any of the thumbnail buttons to change the main image. You may also use the left and right arrow keys to navigate between images.
dbx Di1 Active Single Channel Direct Box, Main
dbx Di1 Active Single Channel Direct Box, Front
dbx Di1 Active Single Channel Direct Box, Rear
dbx Di1 Active Single Channel Direct Box, Top
dbx Di1 Active Single Channel Direct Box, Main dbx Di1 Active Single Channel Direct Box, Front dbx Di1 Active Single Channel Direct Box, Rear dbx Di1 Active Single Channel Direct Box, Top
Go direct with DBX's workhorse DI box. The Di1 features a tough metal chassis, switchable -20/-40 dB pad, and a 9V battery to power its active electronics.

The dbx Di1 is a compact high-quality active direct injection box. Ideal for both studios and on the road, the Di1 will ensure audio signals reach their intended destination in both a balanced format and free from unwanted noise.

Connect the output from electric guitars, bass amplifiers, keyboards, etc., directly to a console mixer without the use of a microphone.

Built for toughness and reliability, the Di1 has all the features of a fully featured gig-ready workhorse DI unit.

Recommended for: Studio, Tour, and Portable.

Features:

- Level and impedance matching function
- Output impedance: > 600 Ohms
- Signal pass through connector
- Output connector: XLR balanced
- Battery LED indicator
- Distortion: (THD) < 0.005% at 1kHz, 0dBu
- Phantom power LED indicator
- Max Input: +12dBu (at 0dB) Level +32dBu (at -20dB) +52dBu (at -40dB)
- Output Noise: <-100dB unweighted
- TS and XLR inputs and outputs
- Frequency response: 10Hz to 70kHz, +0dB/-3dB
- Attenuation control
- Phantom Power: +18 volts DC to +48 volts DC
- Ground lift switch
- Main/Standby: 9V battery
- Input Impedance: >250k Ohm
- Metal Chassis

- Input Impedance: > 250k Ohm
- Max Input: +12dBu (at 0dB) Level +32dBu (at -20dB) +52dBu (at -40dB)
- Connectors: Two Parallel 1/4" jack connectors and a parallel XLR connector (unbalanced), 1/4" Jack: Tip Hot, Sleeve Ground; XLR Jack; Pin 2 Hot, Pins 1 & 3 Ground
- Output Impedance: > 600 Ohms
- Output Connectors: XLR balanced
- Distortion: (THD) < 0.005% at 1kHz, 0dBu
- Output Noise: <-100dB unweighted
- Frequency Response: 10Hz to 70kHz, +0dB/-3dB
- Main/Standby: 9 Volt battery
- Phantom Power: +18 Volts DC to +48 Volts DC

For support or warranty questions, please contact the manufacturer:
Phone: 844-776-4899
Web: https://www.dbxpro.com/en/support

Be the first to rate and review this product.

No longer available at zZounds

In most cases, a product is unavailable because it has been discontinued by the manufacturer