DBX DriveRack VENU360 Complete Speaker Manager

Get more out of your PA! The DriveRack Venu360 packs powerful AutoEQ, feedback suppression, dbx compression and more -- controllable from your mobile device.

$1,125.00

  • 18 x  
  • 12 x  
    $93.75
  • 8 x  
    $140.63
  • No Credit Check
    6 x  
    $187.50
  • No Credit Check
    4 x  
    $281.25

dbx DriveRack 260 EQ and Speaker Control Processor

No longer available at zZounds
Fine-tune your PA system in a single rack unit with RTA, feedback elimination, graphic and parametric EQ, dbx compression/limiting, alignment delay and more.

There is a reason that live sound professionals and discriminating audio contractors choose dbx DriveRack products for their high-end tours and installs. The DriveRack products provide the tools that ensure that the system sounds its very best. With the introduction of the 260, the heritage of unrivaled system/loudspeaker control continues.

The 260 capitalizes on the road tested and contractor approved nature of the other products in the DriveRack line. The 260 provides full bandpass and crossover configurations as well as independent output processing and a full time RTA for live sound applications. Contractors will appreciate its control inputs for wall-panel logic control and the patent-pending Advanced Feedback Suppression (AFS).

The DriveRack 260 continues the legacy of DriveRack series, which has been created by the company that has been redefining the standard of signal processing for more than 30 years. The DriveRack 260 was designed with the purpose and vision of providing state-of-the-art signal processing, while utilizing a simple and intuitive user interface. This goal has been achieved by offering two independent channels of processing power with a linkable 28-Band Graphic Equalizer, industry-standard dbx stereo compressor module, feedback eliminator and the 120A Subharmonic Synthesizer on the input, with a six channel output system that includes parametric EQs, PeakStopPlus(TM) limiters (to provide protection against speaker blowouts) and alignment delay. These read more features combined with the Wizard setup system and complete DriveWare GUI control represent a methodical design that is guaranteed to deliver optimal, all-inclusive processing in a completely scalable system.

Features:

- Feedback Elimination
- 2.7 Seconds of Alignment and Zone Delay
- RS-232 PC GUI control
- Classic dbx Compression and Limiting
- Graphic and Parametric EQ
- Auto-EQ Function
- Full Bandpass, Crossover, and Routing Configurations
- Auto Gain Control
- Pink Noise Generator and fulltime RTA
- Setup Wizard with JBL speaker and Crown Power Amplifier Tunings
- Security Lockout
- Wall Panel Control Inputs
read less

Analog Inputs
- Number of Inputs: (2) Line inputs. (1) RTA Mic input
- Connectors: (2) Female XLR line inputs. XLR RTA Mic input
- Type: Electronically balanced/RF filtered
- Impedance: >40 k ohm
- Max Input line level: +34dBu with input jumpers in +30 position
- CMRR: >45 dB
- RTA Mic Phantom Voltage: +15 VDC
- RTA Mic EIN: <-110 dBu, 22 Hz - 22 kHz, 150 ohm

Analog Outputs
- Number of Outputs: 6
- Connectors: Male XLR
- Type: Electronically balanced, RF filter
- Impedance: 120 ohms
- Max Output Level: +22dBu

A/D Performance
- Type: dbx Type IV conversion system
- Dynamic Range line: >114 dB A-weighted, >112 dB unweighted
- Type IV dynamic range: >119 dB, A-weighted, 22kHz BW, >117 dB, A-weighted, 22kHz BW
- Sample Rate: 48 kHz

D/A Performance
- Dynamic Range: 112 dB A-unweighted, 110 dB unweighted

System Performance
- Dynamic Range: 110 dB unweighted, >107 dB weighted
- THD + N: 0.002% typical at +4 dBu, 1 kHz, 0 dB input gain
- Frequency Response: 20 Hz - 20 kHz, +/-0.5 dB
- Interchannel Crosstalk: >110 dB, 120 dB typical
- Crosstalk input to output: >100 dB

For support or warranty questions, please contact the manufacturer:
Phone: 844-776-4899
Web: https://www.dbxpro.com/en/support

No longer available at zZounds