Samson VHFTD Series QMic Handheld Wireless Microphone System

No longer available at zZounds

zZounds Gear Experts Say...

System Includes: VR3TD True Diversity Receiver, VH3 Handhel Mic Transmitter with Samson Q MIC Dynamic Capsule.

Overview

If you're looking for professional wireless at prices that make sense, VHF Series was designed for you. No matter whether you're into fitness training, public speaking or musical performance, you'll want VHF Series' great reception and sound without going over budget.

System Includes: VR3TD True Diversity Receiver, VH3 Handhel Mic Transmitter with Samson Q MIC Dynamic Capsule.

Features
Advanced wireless circuitry for super-reliable RF reception

Detachable 3-pin connector for lavalier and headset mics that locks into position to reduce cable connection problems

Rugged, triple-strength cable strain relief on instrument beltpack transmitter

Receiver features a front panel 5-segment Audio Level Meter

Balanced XLR and unbalanced 1/4 in. outputs with Mic/Line switch

Extended 18-hour transmitter battery life with 3-segment LED Battery Life Meter

300 ft. minimum distance transmission range

Samson noise reduction for whisper-quiet performance

13 available channels

3-year limited warranty

Specs

System Includes: VR3TD True Diversity Receiver, VH3 Handhel Mic Transmitter with Samson Q MIC Dynamic Capsule.

Transmitter (VT3L, VT3, and VH3)
Transmission Mode: Frequency modulation, 80KF3E, 20 kHz peak deviation

Frequency Range: 173.80 MHz to 213.20 MHz, 25 frequencies
Band A (European/UK models): 160.10 to 177.90 MHz
Band B (European/UK models): 189.10 to 210.10 MHz

OSC System: Crystal controlled, x9 multiplication

RF Power: 20 mW (USA models), 2 mW (European/UK models)

Operating Range: 300 ft.

Frequency Stability: ± 10 ppm

Approvals: Complies with ETS 300 422 and FCC Part 74

Radiating Harmonic and Spurious Emission: Below limits of applicable regulations

Antenna Type: Internal

Audio Frequency Response: 40 Hz to 16 kHz ±3 dB

Pre-Emphasis: 50 µSec

Noise Reduction System: NE571 based compandor

Signal to Noise Ratio: > 100 dB

Maximum Input Level: 0 dBv (VT3L, VT3), -20 dBv (VH3)

T.H.D.: < 1% @ 1 kHz

Current Consumption: 32 mA (typical)

Battery Life (MN1604 9-volt alkaline): 14 hours (typical)

Operating Temperature: -10 to +55 degrees C

Controls:
VT3L/VT3 Power On/Off, Mute On/Off, Level Control (Trimpot)
VH3 Power On/Off, Audio On/Off, Level Control (Trimpot)
LED Indicator Battery high/medium/low

Dimensions (W x H x D):
VT3L/VT3: 65 x 22 x 100 mm (2.6 x .87 x 4 in.)
VH3: 37 x 240 mm (1.46 x 9.45 in.)

Weight: 110 g (3.9 oz.)

Receiver (VR3TD and VR3)
Receiving System:
VR3TD: Single conversion Superheterodyne, Microprocessor True Diversity
VR3: Single conversion Superheterodyne, Non-Diversity

Frequency Range: 173.80 MHz to 213.20 MHz, 25 frequencies
Band A (European/UK models): 160.10 to 177.90 MHz
Band B (European/UK models): 189.10 to 210.10 MHz

Receiving Mode: 80KF3E

Sensitivity: < 3 µV for 20 dB SINAD, < 10 µV for 50 dB S/N

Selectivity: 120 kHz BW, nominal @ -6 dB, ± 300 kHz (adj CH), -75 dB

Squelch Sensitivity: 2.5 µV to 250 µV adjustable

IF: 10.7 MHz

Local Oscillator System: Crystal controlled

Noise Reduction System: NE571 based compandor

De-emphasis: 50 µsec.

Signal To Noise Ratio: > 100 dB (IHF-A) line out, > 90 dB (IHF-A), mic out

Audio Frequency Response: 40 Hz to 16 kHz ±3 dB

T.H.D.: < 1% @ 1 kHz

Audio Output Levels: -10 dB unbalanced (1/4 in. phone connector), -20 dBm / -40 dBm balanced (XLR connector)

Audio Output Impedance: 5 ohms unbalanced, 600 ohms balanced

Antennas: 1/4 wavelength telescopic

Operating Temperature: -10 to +55 degrees C

Controls: Volume, Squelch, Power

LED Indicators:
VR3TD TX On / Antenna A or B (2 LEDs) / Power / AF Level (5 LEDs)
VR3 TX On / Power/ AF Level (5 LEDs)

Power Requirement: 12 Volts DC, 80 mA typical (160 mA max.), AC adapter supplied

Dimensions — without antennas (W x H x D): 215 x 44 x 80 mm (8.5 x 1.75 x 3.2 in.)

Weight (including antennas): 300 g (0.7 lbs.)