JBL C5 Control 5 Compact Studio Monitor

The Control Series is pure JBL, combining high performance, compact design and rugged construction into a line of loudspeaker systems with unprecedented versatility. The Control Series is also one of the easiest systems to install available anywhere. Perfect for applications where tight corners and tough angles are all too common, the Control Series features a wide variety of available mounting systems allowing enclosures to be easily positioned for optimum performance.

Features
Sensitivity: 89 dB SPL, 1 W, 1 m (3.3 ft).

High power handling (175 W pink noise) with integral protection circuit network.

Molded enclosure with shielded magnet structure.

Technical Info

Frequency Range (+/- 3 dB): 75 Hz to 20 kHz

Power Capacity: 175 Watts

Sensitivity: 89 dB SPL, 1 W, 1 m (3.3 ft)

Directivity Factor (Q): 2.8

Directivity Index (DI): 4.5

System Sensitivity (dB-SPL, 1W @ 1m):
- 30 Hz - 150 Hz:
-- 1 cabinet: 102 dB
-- 2 cabinets: 104 dB
-- 4 cabinets: 107 dB

Nominal Impedance: 4 ohms

Crossover Frequency: 3 kHz

Polarity: Positive Voltage to + terminal causes outward low frequency cone motion

Enclosure Material: Polypropylene structural foam

Dimensions (HxWxD): 387 x 251 x 229 mm, 15.25 x 9.875 x 9 in

Net Weight (each): 4.5 kg (10 lb)

Optional Accessories
MTC51 Wall Mount Bracket: Allows the Control 5 to be mounted to any rigid vertical surface with a unique polymer ball and clamp design, In addition to omnidirectional movement about the ball, the speaker's connecting wires may be run internal to the clamp. Optional colors.

MTC52 Ceiling Mount Bracket: The same as the MTC51 except that it is designed to be Rack Mount Bracket: Allows the Control to be mounted in a standard 19 in EIA equipment rack, with accommodation for vertical adjustment.

Tripod Mounting Adapter: Allows the Control 5 to be mounted to the JBLMT4612 aluminum tripod in either a vertical or horizontal position. MTC56 Wall Mount Bracket:

Low cost, fixed angle wall mount bracket with safety chain.

Note: Accessory attachment points on rear of the enclosure are .25 x 20 in threaded brass bushings,