- In stock
- 1 person rates: 10 out of 10
The PM351 is ideal for live bands and church musicians, as well as studio musicians and singers. Having the ability to monitor a main mix along with the musician's voice and their instrument make the PM351 an effective and versatile tool. Learn More...
- In stock
- 23 people rate: 8 out of 10
Mix your microphone with a main monitor mix for a perfect monitor mix that you can control. This monitor amp also works as a line tester. It has 1/4" input that accepts line and speaker levels and a mic pass-through for mixer connection. Learn More...
- In stock
- 6 people rate: 9 out of 10
The HE18 is a 2-channel audio hum and buzz remover. Everyone knows how annoying it is to have 60 cycle hum in your sound. Now you can eliminate virtually all ground hum and buzz by simply inserting the HE18 into the audio path. Plus, the unit will convert an unbalanced signal into a balanced signal, and vice-versa. This greatly improves overall noise performance. Learn More...
The MX56c, an upgrade to the Rolls MX56s, features 4 inputs including a mono 1/4 in. line input, a stereo 1/8 in. (3.5mm) line input, a balanced XLR microphone input with jumperable phantom power, and a stereo RCA line input. A variety of outputs have also been included on the MX56c. Learn More...
- In stock
- 6 people rate: 8 out of 10
This direct box converts high-impedance to low-impedance and vice cersa. It has a ground lift for hum reduction, and an attenuator switch for connection to line level or speaker level signals. Learn More...
- Only 3 left!
- 3 people rate: 10 out of 10
Any musician or sound person knows how difficult it is to maintain cables. The CT 1 provides an efficient way to detect shorted or open cables. The unit tests 1/4 in. TS, 1/4 in. TRS, RCA, and XLR cables. Plus, it will test combinations of the above. This unit is a must have!
Learn More...
- In stock
- 15 people rate: 9 out of 10
This device has single input, 4-output headphone amplifier, slider volume controls, full frequency response, and lots of output level. (In other words, it's loud!) Learn More...
- Only 1 left!
- 69 people rate: 7 out of 10
The GCi404 mixes a balanced XLR Microphone signal with a 1/4 in. Instrument signal and a group of stereo Line Input signals. The Microphone input has +12 volt phantom power, a variable Level control from no signal to +55 dB of gain, and a Balance control. The Instrument input has a Level control variable from no signal to +30 dB. The Line input group features three types of inputs; stereo RCA, stereo 1/8 in., and a stereo Phono preamp with grounding post and built-in RIAA equalization. Learn More...
- New $249.00
- List: $325.00
- More expected 5/28/2008
- 5 people rate: 7 out of 10
The new Rolls RM203x Stereo Line Mixer is a line-level mixer with nine channels of stereo 1/4 in. inputs, a single XLR Mic Input, a Tape input and output provided via stereo RCA jacks, and a mono auxiliary send and stereo returns. Each channel has a signal Level control, a right/left Balance control, an Auxiliary level control, and a Clip LED indicator. Learn More...
- In stock
- 42 people rate: 7 out of 10
Phono players require special equalization because of the frequency response of recording on vinyl. The VP29 equalizes and amplifies the phono signal to a clean, and full line level for professional amplification. Learn More...
- In stock
- 4 people rate: 10 out of 10
The PB223 is for powering phantom powered microphones with 48VDC. Since the units use a 100KHz switching power supply there is no audio noise generated. Learn More...
- New $299.00
- List: $375.00
- In stock
- 10 people rate: 6 out of 10
Each channel of the RM65b has a monitor send, FX send, bass and treble controls, and a volume slider. Each XLR input has a trim control on the rear panel. Learn More...
- More expected 5/21/2008
- 11 people rate: 7 out of 10
The Rolls CL151 is a very versatile processor and can be used in any application where you need single channel mic or line level input processing. It is primarily designed for connecting studio mics to the inputs of hard disc recorders and has all the input stage processing power you need and an unbalanced 1/4 in. line level output. Learn More...
The new MSC106 microphone stand adapter is perfect for mounting accessories such as headphone amplifiers, 1/2 rack effects, etc. Learn More...
- In stock
- 6 people rate: 8 out of 10
The MX28 is a 3-channel true stereo line mixer. Each channel has an individual 1/4 in. input for the right and left sides, and the outputs are individual right and left 1/4 in. jacks. Each channel has a level and pan (balance) control. The Master Level controls the output volume and the Headphone Level controls the level to the 2 headphone outputs.
Learn More...
