Guitar Effects Power Adapters and Supplies
Morley 9 volt 300mA. Regulated adapter for use with ALL Morley pedals. Center polarity is negative. Equipped with handy LED to show that power is on....
Learn more...
4 People Rated: 5 out of 5
The Power-All Deluxe Kit provides 9 volts DC at 2000 milliamps - more than enough current to power dozens of effect pedals, including up to 4 Line 6 Modelers! The Po...
Learn more...
2 People Rated: 4 out of 5
This power supply works with the current DOD FX Series, the T2 Tuner, the TEC4 and TEC4X, the VOTec, ACOUSTec, and the BASSTec....
Learn more...
7 People Rated: 4.5 out of 5
Connect a Line 6 DC-1 power supply and you'll never need a 9 volt battery again! It is also compatible with most popular 9 volt DC stomp boxes....
Learn more...
The Behringer POWER THE WORLD PSU-HSB-ALL is a all-country compatible DC 9 V / 1.7 A Power Adapter with Daisy-Chain Connectors, Jumper Cables and All-Country Mains A...
Learn more...
Another innovation brought to you by Keith McMillen Instruments the Batt-O-Meter checks hard-to-reach batteries via the 1/4-inch input on most instruments and effect...
Learn more...
6 People Rated: 4 out of 5
Parallel DC cords for (up to) 8 Boss pedals....
Learn more...
12 People Rated: 4.5 out of 5
FuelTank is the power supply for effect users. It gives 1000mA through 10 standard plugs, of which 2 are isolated 12-volt....
Learn more...
15V DC Power supply for Radial and Tonebone pedals....
Learn more...
For all Tech 21 floor/pedal models, except for SansAmp Classic....
Learn more...
1 Person Rated: 5 out of 5
The E-Series Boomerang Power Supply is specifically modeled for powering the E155 Chorus Delay and the E156 Rang III Looper. The E-Series pedals work perfectly with ...
Learn more...
Right Angle Daisy Chain connector with standard polarity tip negative/barrel positive jacks connects the PA-9 Power-All to five effect pedals. The CABLE-5 can also b...
Learn more...
1 Person Rated: 4.5 out of 5
Designed to provide the proper 12V DC power to Dunlop pedals such as the Rockman Guitar Ace, Metal Ace, or Bass Ace. Center positive, 5.5mm plug....
Learn more...
2 People Rated: 5 out of 5
The PA-9S provides 9 volts DC at 2000 milliamps - use it with the C-11/R daisy chain cable (sold separately) to power dozens of effect pedals, including up to 4 Line...
Learn more...
The Diago PS01 Powerstation is the ultimate pedal board power supply. It will power from 1 to 30 pedals without noise or hum....
Learn more...
2 People Rated: 5 out of 5
Add this cable to the Switchmode power supply to power up to 5 more pedals....
Learn more...
11 People Rated: 4.5 out of 5
Not all effect pedals run off 9 volts, and for these oddball units there's the Iso-Pump Voltage Converter. Designed to work specifically with the PA-9 Power-All, the...
Learn more...
This power supply is designed to provide the proper 9V DC power to pre 1993 Dunlop pedals, smaller MXR pedals and the GCB-100 Bass Crybaby....
Learn more...
1 Person Rated: 3 out of 5
The Voodoo Lab Pedal Power AC is a pedalboard power supply designed to operate high current and AC powered pedal effects. Finally, a professional solution for poweri...
Learn more...
1 Person Rated: 5 out of 5
Using proprietary technology, the GH-1 Ground Hound creates an isolated ground connection for any effect unit that is powered off the PA-9 Power-All. Avoid ground lo...
Learn more...