Shure ULXP124/85 Combination Handheld/Lavalier Wireless Microphone System

No longer available at zZounds
Sometimes you need a handheld wireless microphone, sometimes you need a clip-on mic. Switch between them with this Shure ULX-P combination wireless system.

Take Control.

Step up to ULX Professional UHF systems (ULX-P) for professional sound technicians and working musicians. Multiple system configurations provide limitless options, each with a choice of legendary Shure microphones or instrument cables.

Over 1400 selectable, pre-programmed frequencies are available, and Automatic Frequency Selection provides a straight shot to a clear channel. ULX Professional systems offer more advanced features and controls, including lockable settings and group scan function.

- Compatible systems per band: up to 20*
- Compatible systems using multiple bands: 62*
- Selectable frequencies: 1440
- Auto-Setup: Scan / Channel Scan
- Detachable antenna: yes

* Dependent on frequency regulations by country and actual spectrum usage including TV.

ULXP4 Wireless Diversity Receiver Features:

- Up to 1400 selectable frequencies
- Automatic Frequency Selection with group scan function
- Predictive Diversity
- 5-segment audio meter
- 5-segment RF meter
- Advanced multi-function LCD
- 3-segment transmitter battery fuel gauge
- Squelch adjustment
- 1/2 rack design
- Remotable 1/2 wave antennas
- Frequency and volume lockout
- Rugged metal chassis
- Furnished rack hardware
- Locking DC connector
- XLR and 1/4-inch outputs

Handheld or Bodypack Transmitter Features:

- 3-segment battery fuel gauge
- Backlit LCD shows group and channel
- Frequency and power lockout
- Eight hour battery life
- 100m (300 ft.) operating range
-20dB pad switch read more on ULX1

ULXP124/85 Combo Wireless System

- Combo wireless system
- Features SM58 handheld mic & WL185 lavalier mic

System Includes:
- ULXP4 professional diversity receiver
- ULX2 handheld transmitter
- 185 lavalier condenser microphones
- ULX1 bodypack transmitter

Consumer Alert
Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC's wireless microphone website at www.fcc.gov/cgb/wirelessmicrophones

NOTE: None of the wireless systems we carry are capable of violating the FCC guidelines stated above. We are presenting this information as a matter of legally required disclosure.
read less

- RF Carrier Frequency Range: 470.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is used). Refer to the frequency supplement supplied with the system.
- Effective Range: 100 m (300 ft.) under optimal conditions. Actual working range depends on RF signal absorption, reflection, and interference.
- Audio Frequency Response: 25 to 15,000 Hz, +/- 2 dB. Overall system frequency response depends on the microphone element.
- Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output
- Transmitter Gain Adjustment Range:
-- ULX1: 25 dB
-- ULX2: 25 dB
- Receiver Audio Output Level (+/- 38 kHz deviation, 1 kHz tone) :
-- XLR connector (into 600 ohm load): +3.9 dBV (line), -17 dBV (mic)
-- 1/4 inch connector (into 3000 ohm load): -2 dBV
- Impedance:
-- ULX1 (input): 1 Megohm
-- ULXS4, ULXP4 (output): 50 ohms at line level; 2000 ohms at mic level
- Modulation: +/- 38 kHz deviation compressor-expander system with pre- and de-emphasis.
- RF Power Output: 30 mW maximum
- Dynamic Range: >100 dB, A-weighted
- RF Sensitivity: .26 microVolt for 12 dB SINAD (typical)
- Image Rejection: 80 dB typical
- Spurious Rejection: 75 dB typical
- Ultimate Quieting (reference +/- 38 kHz deviation) : >105 dB, A-weighted
- System Distortion (reference +/- 38 kHz deviation, 1 kHz modulation) : 0.3% total harmonic distortion, typical
- Power Requirements:
-- ULX1, ULX2: 9V alkaline battery; 8.4 V Nicad optional
-- ULXP4: 14 - 18 Vdc (negative ground), 550 mA
- Battery Life: 8 to 9 hours (with 9V alkaline battery)
- Operating Temperature Range: -20 degrees to 49 degrees C (-4 degrees to 120 degrees F)Battery characteristics may limit this range.
- Overall Dimensions:
-- ULX1: 96.5 mm H x 67 mm W x 26.7 mm D (3.86" x 2.68" x 1.10")
--ULX2/SM58: 228.6 L x 51 mm Dia. (9" x 2")
-- ULX2/BETA 58: 220.9 mm L x 51 mm Dia. (8.7 x 2")
-- ULX2/SM86: 213 mm L x 49 mm Dia. (8.4" x 1.9")
-- ULX2/87, ULX2/BETA 87: 223.5 mm L x 51 mm Dia. (8.8" x 2")
-- ULX4S: 43 mm H x 214 mm W x 163 mm D (1.72" x 8.56" x 6.52")
-- ULX4P: 43 mm H x 214 mm W x 172 mm D (1.72" x 8.56" x 6.88")
- Net Weight:
-- ULX1: 79 g (2.8 oz.) without battery
-- ULX2/58, ULX2/BETA 58: 289 g (10.2 oz.) without battery
-- ULX2/SM86: 251 g (8.8 oz.) without battery
-- ULX2/87, ULX2/BETA 87: 258 g (9.1 oz.) without battery
-- ULXS4: 1049 g (2 lbs, 5 oz.)
-- ULXP4: 1105 g (2 lbs, 7 oz.)
- ULXP4, ULXS4 Receiver Audio Output:
-- Connecter:
--- Unbalanced (1/4 in.)
--- Balanced (XLR)
-- Impedance:
--- Unbalanced:3 kilohm
--- Balanced
---- Mic. Level: 1848 Ohms
---- Line Level: 75 Ohms
- Pin Assignments:
-- Unbalanced:
--- Tip = Hot
--- Ring/Sleeve = Ground
-- Balanced:
--- 1 = Ground
--- 2 = Hot
--- 3 = Cold
-- Phantom Power Protection: Yes
- ULXP4, ULXS4 Receiver Antenna Input:
-- Connector Type: BNC
-- Actual Impedance: 50 ohms
-- Nominal Input Level: -95 to -30 dBm
-- Maximum Input Level: +6 dBm (-20 dBm recommended)
-- Pin Assignments: Shell = Ground, Center = Signal
-- Voltage for Remote Power: 12 Vdc, 150 mA maximum

For support or warranty questions, please contact the manufacturer:
Phone: 800-516-2525
Email: service@shure.com