Shure LX1493 LX Wireless Diversity Body Pack System

Manufacturer's Description for Shure LX1493 LX Wireless Diversity Body Pack System

Widely used in installed sound and live music applications, the LX Wireless Series delivers exceptional performance and reliability at a moderate price. The LX Wireless Series offers a full line of professional handheld, lavalier, instrument, and headworn microphones, as well as an instrument cable, in addition to a choice of single antenna or diversity receivers that enable users to configure a wireless system suitable for almost any application.

System Includes: LX4 MARCAD Diversity Receiver, LX1 Bodypack Transmitter, WL93 Omnidirectional Microphone zZounds is an authorized dealer of Shure products.

Consists of:
(1) LX2 Handheld Transmitter with Microphone

(1) Single and Dual Rack Mounting Kit

(1) LX4 MARCAD Diversity Receiver

(1) 9V Battery

(1) PS40 Power Supply

(1) Swivel Adapter

(2) 1/4 Wave Antennas

(1) Zippered Transmitter/Accessory Bag

(1) WA555 Grip/Switch Cover for LX2

LX24/58: Includes LX2/58 Handheld Transmitter with SM58 Cardioid Microphone

RF Carrier Frequency Range:
169.445 to 240.000 MHz (available frequencies depend on the applicable regulations in the country where the system is used)

Working Range: 91 m (300 ft) under typical conditions.
*Note: Actual working range depends on RF signal absorption, reflection and interference.

Audio Frequency Response: 50 to 15,000 Hz, +/- 2dB
*Note: Overall system frequency response depends on the microphone element.

Audio Output Level (+/-15 kHz deviation, 1 kHz tone):
XLR connector (into 600 ohm load): 0 dBV (line), -20dBV (mic)
1/4 in. connector (into 3 kOhm load: -8.8 dBV)

Gain Adjustment Range: LX1: 40 dB

Impedances:
LX1 (input): 1 MOhm
LX4 (output): 150 ohms (XLR); 3 kOhm (1/4 in. phone jack)

Modulation:
+/- 15 kHz deviation compressor-expander system with pre- and de-emphasis

RF Power Output:
LX1: 50 mW maximum (complies with FCC and IC regulations)

Dynamic Range: >102 dB, A-weighted

RF Sensitivity: 0.45 mV for 12 dB SINAD (typical)

Image Rejection: 80 dB typical

Spurious Rejection: 75 dB typical

Ultimate Quieting (ref. 15 kHz deviation): >100 dB, A-weighted

Audio Polarity:
Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 with respect to pin 3 of low impedance output and the tip of high impedance 1/4 in. output.

System Distortion (ref. +/- 15 kHz deviation, 1 kHz modulation): 0.3% THD typical

Power Requirements:
LX1: 9V alkaline battery (Duracell MN1604 recommended); 8.4V Nicad optional
LX4: 12.5 - 18 Vdc (negative ground), 400mA

Battery Life: 18 to 20 hours (with Duracell MN1604 9V alkaline battery)

Operating Temperature Range:
-20 to 50 degrees C (-4 to 122 degrees F). NOTE: Battery characteristics may limit this range.

Overall Dimensions:
LX1 (H x W x D): 83 x 64 x 26 mm (3-1/4 x 2-1/2 x 1-1/32 in.)
LX4 (H x W x D): 43 x 214 x 183 mm (1-11/16 x 8-7/16 x 7-3/16 in.)

Net Weight:
LX1: 79 g (2.8 oz.), without battery
LX4: 1,105 g (2 lbs., 7 oz.)