Randall V2 Guitar Amplifier Head

An Amp Like You've Never Seen or Heard Before!
Developed for the guitarist who likes multiple tone shaping options, the highly complex V2 can basically produce any tone you want utilizing a full tube preamp, as well as a classic Randall solid-state preamp. Holding true to their hi-gain roots, Randall has pushed the boundaries of modern design which has resulted in this highly advanced new take on hybrid guitar amplification.

A revolutionary new Tube driven Mosfet power section called "Valve-Dynamic™" powers the V2 with so much reaction and feel that you would swear it was full set of power tubes driving the amp. This 12AT7 driven power circuit not only has the feel, but also an accurate frequency response found only in a full tube power section.

Features:
3 MIDI programmable channels:
Ch.3: All tube preamp with 3-12AX7 preamp tubes. Includes "Attack" switch for tight and loose feel, and "Bright" switch
Ch. 2: Classic Randall S.S. channel with push/pull "Sustain Boost"
Ch. 1: Classic full clean with big headroom

MIDI Assignable 6-band Graphic EQ with single On/Off switch. Can be activated for any/all channels then stored and recalled by the included 5-button MIDI foot controller.

Assignable "series" or "parallel" effects loop with single On/Off switch. Can also be activated for any/all channels then stored and recalled by the included MIDI foot controller.

Master front "Volume" control

Master "Density" control. Adjusts the power amp low end dynamics.

Master "Presence" control. Adjusts the power amp extreme high end dynamics

Mic Eliminator XLR direct recording output

World voltage AC inlet

The New Standard In Hi Gain Amplification
During the development of the new V2 and T2 amplifiers, several ground breaking discoveries allowed us to narrow in on several key factors and obvious differences as to why tube power reacts and feels so much differently than a traditional solid-state power amp. Those discoveries resulted, as you'll soon hear, in the groundbreaking "Valve-Dynamic™" circuit.

Due to Randall's newly designed Tube driven Mosfet power section called Valve-Dynamic™, these amps now clip extremely soft with a natural compression when pushed reacting much like a standard power tube. However, because the frequency response of a standard power tube has very unique characteristics, Randall put an immense amount of R&D into emulating and capturing that response curve to develop a new power circuit and ultimately an entire amp line with true tube feel, dynamics, and tone.

Technical Info

Power: 400 watts @ 4 ohms, 280 watts @ 8 ohms, 500 watts @ 2 ohms

MIDI: In/Thru