ARP Odyssey Synthesizer Module Rev 1

No longer available at zZounds
This is a carousel with one large image and a track of thumbnails on the left side. Select any of the thumbnail buttons to change the main image. You may also use the left and right arrow keys to navigate between images.
ARP Odyssey Synthesizer Module Rev 1, Main
ARP Odyssey Synthesizer Module Rev 1, Angle
ARP Odyssey Synthesizer Module Rev 1, Dawed
ARP Odyssey Synthesizer Module Rev 1, Rear
ARP Odyssey Synthesizer Module Rev 1, Main ARP Odyssey Synthesizer Module Rev 1, Angle ARP Odyssey Synthesizer Module Rev 1, Dawed ARP Odyssey Synthesizer Module Rev 1, Rear
Meet the desktop ARP Odyssey synth. It's got the 1972 original's analog circuitry and white panel, and USB/MIDI ports for modern control and DAW integration.

The unmistakable sound of the ARP Odyssey in a desktop module format; offering all editing and sound specifications from the keyboards - without the keys! CV/GATE including to interface withanalog desktop racks and synths, USB and MIDI for interfacing with controllers and DAWs. Comes in Rev1 (White Panel) and Rev3 (Black/Orange Panel). Neither is a limited edition.

- Polyphony
- Maximum Polyphony: 2 voices for duophonic; normally monophonic
- Controllers
- Transpose Positions: 2 octaves down, normal, 2 octaves up
- Proportional Pitch Control
- Pitch Down Pad (b): about -2 / 3 octave
- Modulation Pad (-)
- Pitch Up Pad (#): about +2 / 3 octave
- Noise Generator
- Noise Spectrum Types: White and pink
- Portamento
- Maximum Speed: About 0.01 ms/oct
- Minimum Speed: About 1.5 seconds/oct
- VCO
- Voltage-Controlled Oscillator
- Waveforms: Sawtooth, square, pulse (dynamic pulse)
- Frequency Range:
- VCO-1 in Low-Frequency Mode: 0.2 to 20 Hz
- VCO-1 and VCO-2 (Audio Range): About 20 Hz to 20 kHz
- Warm Up Drift: 1/30 semitone from turn on max
- Pulse Width: 50 to 5%
- Pulse Width Modulation:
- ADSR: +45%
- LFO: +15%
- Voltage Controlled Response: 1 V/oct
- Maximum Frequency Shifts:
- LFO Sine Wave: +1/2 oct.
- LFO Square Wave: +1.5 oct.
- ADSR: +9 oct.
- S/H: +2 oct.
- (*VCO-1 is low-note priority, VCO-2 is high-note priority)
- VCF
- Voltage Controlled Filter
- Types: Low pass (I: 12 dB/oct., II III: 24 dB/oct.)
- Frequency Range: 16 Hz to 16 kHz
- Maximum Usable Q: 30
- Resonance: 1/2 - self oscillate
- Voltage Controlled Response:
- C3 key (left edge) 0 V
- C6 key (right edge) 3 V
- VCA
- Voltage Controlled Amplifier
- Dynamic Range: 80 dB
- Ring Modulator
- Type: Digital
- Input Signal: VCO-1, VCO-2 (square wave)
- Sample & Hold
- Command Sources: Keyboard or LFO trigger
- Sampled Signals:
- VCO-1 sawtooth wave and square wave
- VCO-2 square wave and pink noise
- Envelope Generators
- ADSR Envelope Generator
- Attack Time: 5 msec. to 5 sec.
- Decay Time: 10 msec. to 8 sec.
- Sustain Level: 0 to 100% or Peak
- Release Time: 15 ms to 10 seconds
- AR Envelope Generator
- Attack Time: 5 ms to 5 seconds
- Release Time: 10 ms to 8 seconds
- Control Input
- Control Input Jacks
- Pedal: 1/4" / 6.3 mm monaural phone jack
- Portamento Foot Switch: 1/4" / 6.3 mm monaural phone jack
- Audio Output
- Low
- Connector: 1/4" / 6.3 mm monaural phone jack
- Maximum Output Level: -20 dBu @ 10 kOhms load
- Output Impedance: 10 kOhms
- High
- Connector: XLR connector
- Maximum Output Level: +4 dBu @ 1 kOhm load
- Output Impedance: 330 Ohms
- Headphones
- Connector: 1/4" / 6.3 mm stereo phone jack
- Maximum Output Level: 50 + 50 mW @ 33 Ohms load
- Output Impedance: 10 Ohms
- (Controllable by volume knob)
- External Analog Audio Input
- Connector: 1/4" / 6.3 mm monaural phone jack
- Maximum Input Level: -10 dBu
- Input Impedance: 22 kOhms
- MIDI: In
- USB: Type B
- CV In/Out Controls
- Keyboard CV (In/Out): 1 V/octave
- Connector: 1/8" / 3.5 mm monaural phone jack
- Gate
- Gate In: +3 V (minimum)
- Gate Out: +10 V, key down; 0 V all keys up
- Connector: 1/8" / 3.5 mm monaural phone jack
- TRIG Connector
- Trig In: +3 V pulse min., 10 \0x03BCsec duration minimum
- Trig Out: +10 V pulse on key depression, 10 \0x03BCsec duration
- Connector: 1/8" / 3.5 mm monaural phone jack
- Power
- Power Supply: AC adapter jack (9 VDC)
- Power Consumption: 6.5 W
- Dimensions: (W x D x H): 19.5 x 10.4 x 3.5" / 496.1 x 264.9 x 88.9 mm
- Weight:8.2 lb / 3.7 kg

For support or warranty questions, please contact the manufacturer:
Web: https://www.korg.com/us/support/

Be the first to rate and review this product.

No longer available at zZounds

In most cases, a product is unavailable because it has been discontinued by the manufacturer