The new NT2-A is a professional large capsule (1 in.) condenser studio microphone with variable pick-up pattern,variable high pass filter and variable pad. These features provide greater creative control and versatility.
Three 3-position switches located on the mic body provide the freedom to step from Figure 8, Cardioid or Omni polar pick-up patterns; from a flat response to either 80 Hz or 40 Hz high-pass filter and a Pad adjustment of 0 dB, -5 dB or -10 dB attenuation.
The heart of the NT2-A is the Australian designed and manufactured TYPE HF1 dual diaphragm capsule. The frequency and transient response of this new transducer has been voiced to complement today s modern recording techniques,and yet still evoke the silky smooth character of the legendary microphones of the 50's and 60's.The NT2-A includes a soft pouch and clip.
Features
The Australian designed and manufactured HF1 1 edge terminated,gold sputtered, dual 5 um diaphragm capsule.
3-position variable polar pattern: Omni, Cardioid &Figure 8; all controlled on the mic.
3-position variable high-pass filter: Flat,80 Hz or 40 Hz.
3-position variable pad:0 dB,-5 dB or -10 dB.
Ultra low noise,transformerless SMT circuitry.
Wide dynamic range.
High strength heat-treated steel mesh head.
Durable satin nickel finish.
Internal capsule shock mounting.
Supplied complete with soft pouch and clip.
Technical Info
Power
The NT2-A is designed to operate from phantom power to the P48 standard.
The NT2-A will operate between 44V and 52V applied with positive polarity to pin 2 and pin 3 of the output XLR connector.
Output Impedance
The NT2-A will operate satisfactorily into a load impedance as low as 1K. If a load below this is used, the output signal level will be reduced.
The NT2-A output is balanced between pin 2 (hot) and pin 3 (cold). Pin 1 is ground.
Specifications
Acoustic principle: Externally polarized 25 mm (1 in.) dual diaphragm.
Directional pattern: Multi-pattern
Frequency range: 20 Hz - 20 000 Hz
Output impedance: 200
Signal /Noise ratio DIN/IEC 651: 87 dB (1 kHz rel 1 Paper IEC651, IEC268-15)
Equivalent noise: 7 dBA SPL (per IEC651, IEC268-15)
Maximum SPL: 147 dB (@1%THD into 1k) 157 dB (@1%THD into 1k) - pad at maximum
Sensitivity at 1 kHz into 1k: -36 dB re 1 Volt/Pascal (16 mV @94 dB SPL) +/- 2 dB
Maximum output voltage: +16 dBu (@1%THD into 1k)
Dynamic range of the mic amplifier: DIN/IEC 651 140 dB (per IEC651, IEC268-15)
Power (Supply voltage): 48 Volts (P48)
Output Connection: 3 pin XLR,balanced output between pin 2 (+) and pin 3 (-). Pin 1 ground
Weight approx.: 860 grm (4.23 oz)
Personal use items that are used at your mouth or in your ear cannot be returned once opened due to health laws. This includes all microphones, guitar talk boxes, ear plugs, and in-ear earphones. 
