Shure LX14 LX Wireless Diversity Body Pack System

No longer available at zZounds
This is a carousel with one large image and a track of thumbnails on the left side. Select any of the thumbnail buttons to change the main image. You may also use the left and right arrow keys to navigate between images.
Shure LX14 LX Wireless Diversity Body Pack System
zZounds Gear Experts Say...
Transmitter. Receiver. Dual antennae. Does not include mic. System Includes: LX4 MARCAD Diversity Receiver, LX1 Bodypack Transmitter, WA302 Instrument Cable

Widely used in installed sound and live music applications, the LX Wireless Series delivers exceptional performance and reliability at a moderate price. The LX Wireless Series offers a full line of professional handheld, lavalier, instrument, and headworn microphones, as well as an instrument cable, in addition to a choice of single antenna or diversity receivers that enable users to configure a wireless system suitable for almost any application. Features dual antennae.

System Includes: LX4 MARCAD Diversity Receiver, LX1 Bodypack Transmitter, WA302 Instrument Cable

LX1 Body-Pack Transmitter

Single and Dual Rack Mounting Kits

LX4 MARCAD Diversity Receiver

Lavalier Microphone or Headworn Microphone (not included with LX14 Model)

PS40 Power Supply

9V Battery

1/4 Wave Antennas

Zippered Transmitter/Accessory Bag

LX14: Includes WA302 Instrument Cable

Note: Microphone not included with Body-Pack Transmitter.

RF Carrier Frequency Range:
169.445 to 240.000 MHz (available frequencies depend on the applicable regulations in the country where the system is used)

Working Range: 91 m (300 ft) under typical conditions.
*Note: Actual working range depends on RF signal absorption, reflection and interference.

Audio Frequency Response: 50 to 15,000 Hz, +/- 2dB
*Note: Overall system frequency response depends on the microphone element.

Audio Output Level (+/-15 kHz deviation, 1 kHz tone):
XLR connector (into 600 ohm load): 0 dBV (line), -20dBV (mic)
1/4 in. connector (into 3 kOhm load: -8.8 dBV)

Gain Adjustment Range: LX1: 40 dB

Impedances:
LX1 (input): 1 MOhm
LX4 (output): 150 ohms (XLR); 3 kOhm (1/4 in. phone jack)

Modulation
+/- 15 kHz deviation compressor-expander system with pre- and de-emphasis

RF Power Output
LX1: 50 mW maximum (complies with FCC and IC regulations)

Dynamic Range: >102 dB, A-weighted

RF Sensitivity: 0.45 mV for 12 dB SINAD (typical)

Image Rejection: 80 dB typical

Spurious Rejection: 75 dB typical

Ultimate Quieting (ref. 15 kHz deviation): >100 dB, A-weighted

Audio Polarity:
Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 with respect to pin 3 of low impedance output and the tip of high impedance 1/4 in. output.

System Distortion (ref. +/- 15 kHz deviation, 1 kHz modulation): 0.3% THD typical

Power Requirements:
LX1: 9V alkaline battery (Duracell MN1604 recommended); 8.4V Nicad optional
LX4: 12.5 - 18 Vdc (negative ground), 400mA

Battery Life: 18 to 20 hours (with Duracell MN1604 9V alkaline battery)

Operating Temperature Range:
-20 to 50 degrees C (-4 to 122 degrees F). NOTE: Battery characteristics may limit this range.

Overall Dimensions:
LX1 (H x W x D): 83 x 64 x 26 mm (3-1/4 x 2-1/2 x 1-1/32 in.)
LX4 (H x W x D): 43 x 214 x 183 mm (1-11/16 x 8-7/16 x 7-3/16 in.)

Net Weight:
LX1: 79 g (2.8 oz.), without battery
LX4: 1,105 g (2 lbs., 7 oz.)

For support or warranty questions, please contact the manufacturer:
Phone: 800-516-2525
Email: service@shure.com

Be the first to rate and review this product.

No longer available at zZounds

In most cases, a product is unavailable because it has been discontinued by the manufacturer