Shure LX1493 LX Wireless Diversity Body Pack System

No longer available at zZounds

zZounds Gear Experts Say...

Receiver. Transmitter. Mic. Dual antennae. System Includes: LX4 MARCAD Diversity Receiver, LX1 Bodypack Transmitter, WL93 Omnidirectional Microphone

Overview

Widely used in installed sound and live music applications, the LX Wireless Series delivers exceptional performance and reliability at a moderate price. The LX Wireless Series offers a full line of professional handheld, lavalier, instrument, and headworn microphones, as well as an instrument cable, in addition to a choice of single antenna or diversity receivers that enable users to configure a wireless system suitable for almost any application.

System Includes: LX4 MARCAD Diversity Receiver, LX1 Bodypack Transmitter, WL93 Omnidirectional Microphone

Specs

Consists of:
(1) LX2 Handheld Transmitter with Microphone

(1) Single and Dual Rack Mounting Kit

(1) LX4 MARCAD Diversity Receiver

(1) 9V Battery

(1) PS40 Power Supply

(1) Swivel Adapter

(2) 1/4 Wave Antennas

(1) Zippered Transmitter/Accessory Bag

(1) WA555 Grip/Switch Cover for LX2

LX24/58: Includes LX2/58 Handheld Transmitter with SM58 Cardioid Microphone

RF Carrier Frequency Range:
169.445 to 240.000 MHz (available frequencies depend on the applicable regulations in the country where the system is used)

Working Range: 91 m (300 ft) under typical conditions.
*Note: Actual working range depends on RF signal absorption, reflection and interference.

Audio Frequency Response: 50 to 15,000 Hz, +/- 2dB
*Note: Overall system frequency response depends on the microphone element.

Audio Output Level (+/-15 kHz deviation, 1 kHz tone):
XLR connector (into 600 ohm load): 0 dBV (line), -20dBV (mic)
1/4 in. connector (into 3 kOhm load: -8.8 dBV)

Gain Adjustment Range: LX1: 40 dB

Impedances:
LX1 (input): 1 MOhm
LX4 (output): 150 ohms (XLR); 3 kOhm (1/4 in. phone jack)

Modulation:
+/- 15 kHz deviation compressor-expander system with pre- and de-emphasis

RF Power Output:
LX1: 50 mW maximum (complies with FCC and IC regulations)

Dynamic Range: >102 dB, A-weighted

RF Sensitivity: 0.45 mV for 12 dB SINAD (typical)

Image Rejection: 80 dB typical

Spurious Rejection: 75 dB typical

Ultimate Quieting (ref. 15 kHz deviation): >100 dB, A-weighted

Audio Polarity:
Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 with respect to pin 3 of low impedance output and the tip of high impedance 1/4 in. output.

System Distortion (ref. +/- 15 kHz deviation, 1 kHz modulation): 0.3% THD typical

Power Requirements:
LX1: 9V alkaline battery (Duracell MN1604 recommended); 8.4V Nicad optional
LX4: 12.5 - 18 Vdc (negative ground), 400mA

Battery Life: 18 to 20 hours (with Duracell MN1604 9V alkaline battery)

Operating Temperature Range:
-20 to 50 degrees C (-4 to 122 degrees F). NOTE: Battery characteristics may limit this range.

Overall Dimensions:
LX1 (H x W x D): 83 x 64 x 26 mm (3-1/4 x 2-1/2 x 1-1/32 in.)
LX4 (H x W x D): 43 x 214 x 183 mm (1-11/16 x 8-7/16 x 7-3/16 in.)

Net Weight:
LX1: 79 g (2.8 oz.), without battery
LX4: 1,105 g (2 lbs., 7 oz.)